为lo0设置了alias之后panabit管理界面无法显示

ec0131

如图
uname -a
FreeBSD pbt 6.3-RELEASE-p4 FreeBSD 6.3-RELEASE-p4 #0: Wed Sep  3 00:08:54 UTC 2008     root@i386-builder.daemonology.net:/usr/obj/usr/src/sys/SMP  i386

ifconfig设置
rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        options=8<VLAN_MTU>
        inet 192.168.1.124 netmask 0xffffff00 broadcast 192.168.1.255
        inet 192.168.1.125 netmask 0xffffff00 broadcast 192.168.1.255
        inet 192.168.1.122 netmask 0xffffff00 broadcast 192.168.1.255
        ether 00:e0:4d
        media: Ethernet autoselect (100baseTX <full-duplex>)
        status: active
rl1: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
        options=8<VLAN_MTU>
        ether 00:e0:4c
        media: Ethernet autoselect
        status: no carrier
fxp0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500
        options=8<VLAN_MTU>
        ether 00:08:02
        media: Ethernet autoselect (100baseTX <full-duplex>)
        status: active
fxp1: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500
        options=8<VLAN_MTU>
        ether 00:08:02  
        media: Ethernet autoselect (100baseTX <full-duplex>)
        status: active
plip0: flags=108810<POINTOPOINT,SIMPLEX,MULTICAST,NEEDSGIANT> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x6
        inet6 ::1 prefixlen 128
        inet 10.10.10.2 netmask 0xffffff00
        inet 127.0.1.0 netmask 0xffffff00
        inet 10.10.10.3 netmask 0xffffff00
        inet 10.10.10.4 netmask 0xffffff00

[ 本帖最后由 ec0131 于 2008-9-5 16:44 编辑 ]

ihweb

lo0 没必要设置啊！

ec0131

我设置了当然有用哦

ec0131

木有人理了

pan

你在其他电脑上试过没有？会不会与的你ＩＥ设置相关呢？
ＰＳ：我是第一次装ＦＲ与Ｐ２Ｐ，我现在正常使用中呢！