安装失败!

panabit

你使用下面的特征库更新一下系统，然后在shell里执行如下命令：
1. /usr/panabit/bin/ipectrl stop
2. clear
3. /usr/panabit/bin/panaos -debug
   然后将第三条命令的输出贴上来。
   谢谢！

hurd

执行后输出结果
root@Panabit ~# /usr/panabit/bin/panaos -debug
begin to run debug panaos
Load module "pci" ......
        fxp1@bus2:4:0: 0x8086:0x1229
        fxp2@bus2:5:0: 0x8086:0x1229
Load module "cmds" ......
Load module "dma" ......
This is standard version, no PANAOS DMA supported!
Load module "mgmt" ......
Load module "mbuf" ......
        jos_mbuf_minit: 64 mbuf allocated
Load module "intf" ......
Load module "em" ......
JOSEM not installed!
Load module "bsd" ......
        interface fxp1 attached, mac address 00:50:8B:B2:E3:75
        bring interface fxp1 up
        interface fxp2 attached, mac address 00:50:8B:B2:E3:76
        bring interface fxp2 up
Load module "ipe" ......
Load module "watcher" ......
Load module "tbucket" ......
Load module "key" ......
Load module "keytable" ......
Load module "flow" ......
        flow size 68, entry size 32
Load module "node" ......
        table size 131072, pool size 131072,node size 32
Load module "xping" ......
Load module "axpgrp" ......
Load module "protocol" ......
Load module "port" ......
port module initialzied, max port 65536
Load module "localip" ......
Load module "iptable" ......
Load module "policy" ......
Load module "license" ......
Load module "axpstat" ......
Load module "thread" ......
Load module "xping" ......
Load module "flow" ......
        share CPU with control plane!
Load module "config" ......
This is standard version, no license needed!
Warning: no configuration file found
begin to start thread xping ...
begin to start thread flow ...
flow(0x8402400) start executing...

执行到这里就停止了，我等了十分种还是没反应。就按下了终止键。
--------------------------------
^CMGMT thread begin to exit ...
Notify all other threads to exit ...
notify thread xping(0x8402300) to exit ...
xping thread exit
thread xping exited!
notify thread flow(0x8402400) to exit ...
flow thread exit
thread flow exited!
unload module "config"
unload module "flow"
unload module "xping"
unload module "thread"
unload module "ipe"
unload module "axpstat"
unload module "license"
unload module "policy"
unload module "iptable"
unload module "localip"
unload module "port"
port module finished
unload module "protocol"
unload module "axpgrp"
unload module "xping"
unload module "node"
node module finished
unload module "flow"
unload module "keytable"
unload module "key"
unload module "tbucket"
unload module "watcher"
ipe engine finished
unload module "bsd"
unload module "em"
unload module "intf"
unload module "mbuf"
unload module "mgmt"
unload module "dma"
unload module "cmds"
unload module "pci"

升级后再启动就失败了，上不了网。打开管理界提示有错误。应用协议是空的。
-----------------------------------
Load module "xping" ......
Load module "axpgrp" ......
Load module "protocol" ......
Load module "port" ......
port module initialzied, max port 65536
Load module "localip" ......
Load module "iptable" ......
Load module "policy" ......
Load module "license" ......
Load module "axpstat" ......
Load module "thread" ......
Load module "xping" ......
Load module "flow" ......
        share CPU with control plane!
Load module "config" ......
This is standard version, no license needed!
Warning: no configuration file found
panaos startup!
loading configuration .....
begin to start thread xping ...
Loading configurations into kernel ......
turn on local ip statistic!
begin to start thread flow ...
no name
no name
kern.jos.ipe_policyid: 1 -> 0
kern.jos.ipe_planid: 1 -> 0
close: -1 0
handle_request: socket error Connection reset by peer(54)
configuration loaded!
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)
close: -1 0
handle_request: socket error Connection reset by peer(54)

[ 本帖最后由 hurd 于 2008-5-21 14:50 编辑 ]